Ricoh D093 - Minimum Space Requirements

Preparation
D093/D094 3-2 SM
 The machine will not be directly exposed to reflected heat from a space heater in the
winter.
7. Do not install the machine in an area filled with gases that can cause corrosion.
 Never set up the machine where it will be exposed to ammonia fumes.
 Ammonia in the surrounding area can cause poor reproduction of filled areas in
images.
 If exposing the machine to ammonia in the air cannot be avoided, and if poor
reproduction in filled areas of the images is visible, do SP2201-2 and enter a
setting 50 steps lower than the current setting.
8. Do not install the machine in areas higher than 2,000 m (6,600 ft) above sea level.
9. Put the machine on a strong and level surface.
 The floor must be able to support a load of more than 2.94 kPa (300 kgf/m
2
.
10. Do not install the machine in an area where there are frequent strong vibrations.
3.1.2 MINIMUM SPACE REQUIREMENTS
1. Front: 1000 mm (40")
2. Back: 600 mm (23")
3. Right: 600 mm (23")
4. Left: 600 mm (23")