Main Machine Installation (D093/D094)
D093/D094 3-18 SM
If the machine is not level, use a wrench to adjust the nuts on each foot to raise or lower the
main machine at each corner.
The main machine must be level side-to-side within ±0.15/m.
Normally, the adjustment with the level on the exposure glass is not required.
However, if you have to do the adjustment with the level on the exposure glass, go
back to Step 5 and do the adjustment again with the level on the development unit.
Developer
1. Push up the buttons [1] to release the upper unit. Then open the upper unit [2].
2. Open the toner hopper cover [3].
3. Remove all tape and packing materials [4] in the upper unit.
4. Slowly pull out the drum protection sheet [5].
A developer lot number is embossed on the top edge of each package. Save these
top edges after you open each developer package. You will need these numbers
when you enter them later with SP2801-2 and -3.
To Next Page
Loading...
