Main Machine Installation (D093/D094)
SM 3-19 D093/D094
Installation
5. Open a 1 kg pack of developer and pour it into the development unit.
Do not add the second pack at this time.
Open the first pack of developer [1].
Slowly add the developer from the first pack into the development unit, as you move
the pack from left to right until the pack is empty.
An equal amount of developer must be spread along the entire open slot of the
development unit.
6. Close the toner hopper cover [2].
7. Close the upper unit [3].
8. Connect the power supply cord.
To ensure safe operation of the machine, always make sure that the machine is
grounded at the power source.
9. Switch the main power switch on.
If the development motor starts, wait 50 sec. for it to stop. Go to Step 13.
-or-
If the development motor does not start, go to the next step.
10. Open SP2924-1. Change the "1" setting to "3".
11. Switch the main power switch off/on. The development motor starts. Wait 50 sec. for it to go
off.
12. Open SP2924-1. Change the "3" setting to "1".
13. Turn the main power switch off.
14. Disconnect the power cord.
15. Open the upper unit.
16. Open the toner hopper cover.
To Next Page
Loading...
