Ricoh D093 - Step 7: Printer: Leading Edge, Side-To-Side Registration

Special Adjustments
SM 5-107 D093/D094
Replacement
and
Adjustment
Step 7: Printer: Leading Edge, Side-to-Side Registration
1. Use a sheet of blank plain paper to print the IPU Printing test pattern (SP4417 Pattern 28)
for each paper feed station installed on the machine:
 Manual feed (bypass)
 Roll Feeder Roll 1
 Roll Feeder Roll 2
 Paper Cassette
2. Measure the gaps for the leading edge and side-to-side registration.
3. Touch "SP Mode" and adjust these SPs if a measurement is not in the standard range.
SP Standard: Comments
1001-1
5 ±0.5 mm
Leading Edge Registration – 1st Roll
1001-2 Leading Edge Registration – 2nd Roll
1001-3 Leading Edge Registration –Cassette
1001-5 Leading Edge Registration – By-pass Feed
1002-1 Side-to-Side Registration – 1st Roll
1002-2 Side-to-Side Registration – 2nd Roll