Around the Drum
SM 5-37 D093/D094
Replacement
and
Adjustment
3. Loosen screws [A] and [B] and slide the plates to the rear.
4. Remove the LPH [C].
Re-installation
1. New silver ground wires are provided with the new LPH unit.
2. After re-installing the LPH do SP2943, input the values that are printed on the label
attached to the replacement unit. (
p.5-116 "LPH Adjustment with SP Modes")
3. Do SP2952 and input the values that are printed on the label attached to the replacement
unit. (
p.5-116 "LPH Adjustment with SP Modes")
4. Make a test print and adjust if necessary. (
p.5-116 "LPH Adjustment with SP Modes")
To Next Page
Loading...
