Ricoh D093 - Paper Exit Unit

Common Procedures
D093/D094 5-4 SM
5.1.4 PAPER EXIT UNIT
1. Remove the rear cover and controller cover (
x 2). ( p.5-3 "Rear Cover, Controller
Cover")
2. Disconnect the ground wire [A] and connector [B] on the left (
x 2, x 1, x 1).
3. Disconnect the ground wire [C] on the right (
x 1, x 1).
4. Open the paper exit unit [A] and cover.
5. Raise the paper exit unit approximately 30° from horizontal, and pull the unit away from the
left and right hinges [B] and [C].