SP4-xxx Scanner
D093/D094 2-72 SM Appendix
9 Ind. Dot Erase (x1) 1-7 (Weak-Strong)
Sets the level of independent dot erasure to improve the appearance in the
backgrounds of images scanned in the Text/Chart mode.
[0 to 7 / 0 / 1]
0: Default (Off) 1 (Weakest) to 7 (Strongest)
4551
Scanner: Text DFU
These SP codes enhance the quality of originals scanned in the Text mode
(selected on the operation panel).
5 MTF : 0(Off) 1-15 (Weak-Strong)
Sets the MTF coefficient scanned in the text mode. When the original image is
converted to electrical signals, the contrast is reduced due to the influence that
adjacent white and black pixels have on one another as a result of CIS
properties. This may cause very narrow bands or spacing between black and
white areas. Use the MTF adjust to correct this problem and emphasize image
detail.
[0 to 15 / 8 / 1]
0 (Weakest), 8 (Medium: Default), 15 (Strongest)
6 Smoothing: 0 (x1) 1-7 (Weak-Strong)
Sets the level of smoothing for originals scanned in the Text mode.
[0 to 7 / 0 /1 ]
0 (Weakest), 4 (Medium: Default), 7 (Strongest)
7 Brightness:1-255
Sets the overall brightness images scanned in the Text mode.
[1 to 255 / 128 / 1]
1 (Weakest), 128 (Medium: Default), 255 (Strongest)
Note: Raising the brightness level may increase moiré
To Next Page
Loading...
