Energy Save
D093/D094 8-2 SM
Example
Panel off: 1 min.
Low power: 15 min.
Auto Off: 1 min.
The machine goes to Off mode after 1 minute. Panel Off and Low Power modes are not
used.
Return to Stand-by Mode
Low Power Mode
Recovery time: 78 sec.
Off/Sleep Mode
Recovery time: 120 sec.
Recommendation
We recommend that the default settings should be kept.
If the customer requests that these settings should be changed, please explain that their
energy costs could increase, and that they should consider the effects on the environment
of extra energy use.
If it is necessary to change the settings, please try to make sure that the Auto Off timer is
not too long. Try with a shorter setting first, such as 30 min., then go to a longer one (such
as 60 min.) if the customer is not satisfied.
If the timers are all set to the maximum value, the machine will not begin saving energy until
240 minutes has expired after the last job. This means that after the customer has finished
using the machine for the day, energy will be consumed that could otherwise be saved.
If you change the settings, the energy consumed can be measured using SP8941, as
explained below.
To Next Page
Loading...
