Service Program Mode
SM Appendix 2-1 D093/D094
Appendix:
SP Mode
Tables
2. APPENDIX: SP MODE TABLES
2.1 SERVICE PROGRAM MODE
Notation What it means
[range/default step]
Example: [-9 to +9/+3.0/0.1 mm step]. Setting can be adjusted
in the range ±9, value reset to +3.0 after and NVRAM reset,
and the value can be changed in 0.1 mm steps with each key
push.
DFU
“Design or Factory Use”. Do not change this value. The factory
default setting provides optimum performance.
CTL
Means "controller". This is used to denote SP codes that are
related to the GW controller.
Not Used
These SP's appear in the SP mode menus but these codes are
not used because:
Currently the feature is not available for the main machine,
or its use has been discontinued.
The SP is intended for use with a peripheral that is
currently under development but not available at this time.
Note: Executing these SP's has no effect on operation of the
main machine or any peripheral device.
Japan Only
This feature or item is for Japan only. Do not change this value.
Always cycle the machine off/on after changing an SP setting.
To Next Page
Loading...
