Main SP Modes
D093/D094 6-10 SM
1932 Target Temp: Press. Roller
Sets the target fusing temperature of the pressure roller for plain paper,
translucent paper, and film. These temperatures are used for pressure roller
feedback. Turn the machine power off/on after changing the settings.
Important:
Modes "1" to "5" below refer to the paper type and thickness settings
selected in User Tools (see "Paper Thickness Default Selection" in this
section).
After adjusting these SP's, you must turn the machine power off/on.
1 Plain: Mode1 [60 to 180 /100/5
o
C]
2 Plain: Mode2 [60 to 180 /85/5
o
C]
3 Plain: Mode3
[60 to 180 /60/5
o
C] 4 Plain: Mode4
5 Plain: Mode5
6 Trans.: Mode1 [60 to 180 /130/5
o
C]
7 Trans.: Mode2 [60 to 180 /100/5
o
C]
8 Trans.: Mode3
[60 to 180 /60/5
o
C]
9 Trans.: Mode4
10 Trans.: Mode5
11 Film: Mode1
12 Film: Mode2
13 Film: Mode3
14 Film: Mode4
15 Film: Mode5
16 Plain: Low Temp Mode [60 to 180 /120/5
o
C]
To Next Page
Loading...
Need help?
General
