Ricoh D093 - Rapid Sending Control

SP5-xxx Mode
SM Appendix 2-167 D093/D094
Appendix:
SP Mode
Tables
22 Rapid Sending Control
Switches instant transmission off/on.
[0 to 1/1/1]
0: Off. Instant transmission not possible with network setting errors.
1: On. Instant transmission possible with network setting errors.
Note:
 The machine will continue to transmit over the network, even if the network
settings are incorrect. (This causes multiple errors, of course.)
 With this SP off, the machine will stop communicating with the network if the
settings are wrong. This reduces the amount of spurious network traffic
caused by errors due to incorrect settings.
5846 UCS Setting CTL
UCS (User Control Service) is the software that manages user codes and the
address books for scan-to-email and scan-to-folder.
1
Machine ID (for Delivery Server)
Displays the unique device ID in use by the delivery server directory. The value
is only displayed and cannot be changed.
This ID is created from the NIC MAC or IEEE 1394 EUI.
The ID is displayed as either 6-byle or 8-byte binary.
6-byte
%02X.%02X.%02X.%02X.%02X.%02X
8-byte
%02X.%02X.%02X.%02X.%02X.%02X.%02X.%02X
2
Machine ID Clear (Delivery Server)
Clears the unique ID of the device used as the name in the file transfer directory.
Execute this SP if the connection of the device to the delivery server is unstable.
After clearing the ID, the ID will be established again automatically by cycling the
machine off and on.