Table (B854)
SM 3-57 D093/D094
Installation
Connecting the Main Machine and Table
1. Attach the right joint bracket [1] (the spindle [2] must go through the hole). At the same time,
align the plate with the holes for the three screws (blue).
2. Attach screws
, but do not tighten them.
3. While you lift the main machine by its handle [3], set screw
in the lower hole of the
keyhole cutout and tighten it.
4. Tighten screws
, .
5. Do the above procedure again for the left joint bracket [4].
When you attach the left bracket make sure that the bracket does not pinch or
interfere with the harness of the main switch.
6. Reattach the manual feed table (
x 2).
7. Reattach the left and right covers (
x 3 ea.).
Make sure that you attach the longer screws with the fine threads at the rear sides
of the covers.
8. Close the upper unit.
To Next Page
Loading...
