Ricoh D093 - HDD Data Read Failure; HDD Re-Try Failure; HDD Startup Error at Power on

Service Call Tables
D093/D094 7-38 SM
860 B HDD startup error at power on
CTL
HDD is connected but a driver error is detected.
-or-
The driver does not respond with the status of the HDD within 30 s.
 HDD is not initialized
 Level data corrupted
 HDD is defective
861 D HDD re-try failure
CTL
At power on the HDD was detected. Power supply to the HDD was
interrupted after the system entered the energy save mode, but after the
HDD was awakened from the energy save mode it did not return to the
ready status within 30 sec.
 Harness between HDD and controller board disconnected, defective
 HDD power connector disconnected
 HDD defective
 Controller board defective
863 D HDD data read failure
CTL
The data written to the HDD cannot be read normally, due to bad sectors
generated during operation.
 HDD defective
Note:
 If the bad sectors are generated at the image partition, the bad sector information is written
to NVRAM.
 The next time the HDD is accessed, these bad sectors will not be accessed for read/write
operation. The HDD will probably require replacement soon.