Ricoh D093 - NVRAM Upload

Boards
SM 5-93 D093/D094
Replacement
and
Adjustment
5.9.4 NVRAM
1. Remove the controller board (
p.5-90 "Controller Board")
2. Press in on the sides of the NVRAM [A] this lift it off the controller board.
 If you change the controller board, put the old NVRAM on the new board.
NVRAM Upload
Do this procedure to upload the NVRAM data from NVRAM to an SD card. Do this procedure
before replacing the NVRAM.
1. Switch the machine off.
2. Insert an SD card in SD card Slot 2.
3. Switch the machine on.
4. Go into the SP mode and do SP5824 (Upload NVRAM Data).
5. When you see "Completed!", switch the machine off.