SP5-xxx Mode
D093/D094 2-178 SM Appendix
5856 Remote ROM Update CTL
When set to “1” allows reception of firmware data via the local port (IEEE
1284) during a remote ROM update. This setting is reset to zero after the
machine is cycled off and on.
[0 to 1 / 0 / 1]
0: Not allowed
1: Allowed
5857 Save Debug Log CTL
1
On/Off (1:ON 0:OFF)
Switches on the debug log feature. The debug log cannot be captured until
this feature is switched on.
[0 to 1/0/1]
0: OFF
1: ON
2
Target (2: HDD 3: SD Card)
Selects the destination where the debugging information generated by the
event selected by SP5858 will be s to red if an error is generated
[2 to 3 /2/1]
2: HDD
3: SD Card
5
Save to HDD
Specifies the decimal key number of the log to be written to the hard disk.
6
Save to SD Card
Specifies the decimal key number of the log to be written to the SD Card.
9
Copy HDD to SD Card (Latest 4 MB)
Takes the most recent 4 MB of the log written to the hard disk and copies
them to the SD Card.
A unique file name is generated to avoid overwriting existing file names on
the SD Card. Up to 4MB can be copied to an SD Card. 4 MB segments can
be copied one by one to each SD Card.
To Next Page
Loading...
