Scanner
D093/D094 5-28 SM
OP-L Board
1. Remove the operation panel ( p.5-25 "Removing the Operation Panel")
2. Remove the LCDC (
p.5-26 "LCDC, Inverter, LCD Display Window, LCD Unit")
3. Remove the OP-L board ( x5).
Touch Screen Calibration
Always re-calibrate the screen after replacing the LCDC.
Do not attempt to use other items on these menu. Items other than "Touch Screen
Adjust" are for design use only.
To avoid errors, do not touch the [Reset] key on the operation panel during this
procedure.
1. Push [Clear], push [1] [9] [9] [ 3], and then press [Clear/Stop] 5 times.
2. Touch "[1] Touch Screen Adjust" on the touch-panel or push [1] on the operation panel.
To Next Page
Loading...
Need help?
General
