Roll Feeder (D503/D504)
SM 3-43 D093/D094
Installation
4. Remove the rear plate [1] of the roll feeder (
x 2).
5. Remove the metal brackets [2], [3] (
x 1 each). Discard these brackets and screws.
6. Remove the shipping tape from the roll feeder harnesses between the bottom of the main
machine and top of the roll feeder.
7. Route the harness (
x 1) through bracket [4] then attach the bracket ( x 2). (Use one
screw from the accessories.)
8. Route the harness (
x 2) through bracket [5] and then attach the bracket ( x 2). (Use
one screw from the accessories).
9. Attach ferrite core [1].
10. Connect the left harness [2] to CN103 on the PSU ( x 1, x 1).
11. Connect the right harness [3] to CN220 and CN221 on the MCU (
x 2, x 3).
12. Reattach:
Shield cover
Controller box cover
Rear cover
To Next Page
Loading...
