USB 2.0/SD Slot Type E (D534)
SM 3-69 D093/D094
Installation
16. Use a clean cloth moistened with alcohol to wipe and clean the points where the clamps will
be attached at [1], [2], [3].
17. Attach clamps [1] and [2].
18. Attach clamp [3] so it is aligned with the edges of the slot covers above.
19. Route the cable and close the clamps (
x3).
20. Re-set plate [1].
Remove the plate ( x1).
Rotate it clockwise 180 degrees.
Re-attach the plate ( x1).
21. Connect the USB cable [2].
22. Coil and secure the loose cable at [3] (
x1).
23. Confirm that the coiled cable is not visible at [4].
24. Plug in the machine and turn it on.
25. Do SP1013 (Multi Media Function). Set "0" to "1" to enable the unit.
To Next Page
Loading...
