Installation of MFP Options
SM 3-87 D093/D094
Installation
8. Attach the ferrite core provided with the Gigabit Ethernet Board to the end of the cable [1] to
be attached to the network.
9. Attach the ferrite core provided with the main machine to the end of the cable [2] to be
attached to the main machine.
Attach both cores 4.5 cm (about 2 in.) from each end of the cord.
10. Reconnect the machine to its power source and turn the main power switch on.
11. Do SP5985-1, SP5985-2 and make sure that both are set to "1" (enable).
12. Turn the machine’s power off/on.
13. Print a Configuration Page to make sure that the machine recognizes the installed board for
USB2.0:
User Tools > Printer Features > List/Test Print > Configuration Page
To Next Page
Loading...
