Ricoh D093 - Page 225

Development
SM 5-43 D093/D094
Replacement
and
Adjustment
 Save the top of the pack. You will need the number to enter the lot number with
SP2801.
20. Use a clean cloth to clean the edges around the slot of the development unit.
21. Install the development unit in the machine and close the toner hopper cover.
22. Close the upper unit. Make sure that the upper unit locks on each side.
23. Switch the main power switch on.
24. Go into the SP mode, enter the developer lot numbers, then mix the developer and initialize
the ID sensor.
 First, do SP2801-2 and -3 and use the soft keyboard on the display panel to enter the
lot numbers to enter the lot numbers of both developer packs.
 You must enter the lot numbers with SP2801-2 and -3 before doing SP2801-1.
The machine will return an error ("Failed") if you attempt to do SP2801-1
before SP2801-2 and -3.
 If the lot numbers are the same, just enter the same number twice.
 Do SP2801-1 to mix the developer and initialize the ID sensor.