Ricoh D093 - Page 230

Drum
D093/D094 5-48 SM
3. On the right, remove hub [1](
x 2)
4. Remove drive belt plate [2] with washer, spacer (
x 4).
5. Loosen screw [3] and remove screw [4] (
x1).
6. Press swivel plate [5] to release pressure on the drive belt and remove the belt.
7. Use the long end of Allen key to loosen the two Allen screws [6].
8. Remove drum gear [7].
 Handle the drum gear carefully to avoid dropping and losing the two Allen screws
inside the gear.
9. Remove left hub [8] of drum shaft (
x 2).
10. Disconnect the drum at [9] (
x1, x1).
11. Confirm that the drum is disconnected at the left rear corner [A].
12. Remove drum unit [A].