SP2-xxx Drum
SM Appendix 2-41 D093/D094
Appendix:
SP Mode
Tables
3 ID Sensor Pattern: High Duty Copy Jobs
This SP sets the development bias applied to create the ID sensor pattern on
the drum when the High Duty Mode is selected with SP2201-4 (factory
adjusted).
[100 to 1000 / 400 /1 V step]
4 Copy Jobs
This SP is used to switch between Low Duty Mode and High Duty Mode.
Note: The Low Duty Mode is set as the default because wide format copiers
are generally used for low volume copying and printing.
[0 to 1/0/1]
0: Low Duty Mode Copy Jobs (< 400 meters/day)
1: High Duty Mode Copy Jobs (> 400 meters/day)
2207 Forced Toner Supply
Push [Execute] to force toner supply. Make a copy and check the image
density. This SP supplies more toner to make light copies darker. Each time
this SP is done, toner is supplied one time.
After [Execute] is pressed the main motor, charge unit, and other
components turn on, then the machine supplies a prescribed amount of
toner to the development unit.
If image density is light, use this SP to recover from a low toner supply
problem.
After executing forced toner supply, the Vsp value displays in the range
0.1 to 0.4 V, and thereafter, the value is stabilized (near 0.4 V) for
subsequent printouts.
To Next Page
Loading...
