Overview
SM 2-15 D093/D094
Product
Information
With the left upper output stackers [A] installed on the machine, the operator can select either
the upper path or the lower path on the operation panel.
Either “Upper” or “Lower” (Copy Output Location) can be selected on the operation panel. The
operator touches “Upper” or “Lower” under “Copy Output Location” on the display to select the
exit :
“Upper”: Copy feeds out to the top of the machine.
“Lower”: Copy feeds out the rear.
If the upper output stackers [1] are removed:
The paper exit selection switch [2] under the left output stacker comes up.
“Lower” is selected for the “Copy Output Location” on the operation panel, so the copy
always feeds out the rear. “Upper” cannot be selected.
If the operator touches “Upper” a message will prompt the operator that the output
destination cannot be selected.
To Next Page
Loading...
