SP2-xxx Drum
SM Appendix 2-59 D093/D094
Appendix:
SP Mode
Tables
23
OFF Timing: Cut Paper: Film
[0 to 35 / 8 / 1 mm]
25
Transfer Current ON Timing
[-5 to -20 / -10 / 1 mm]
2926 Used Toner Overflow Detect
The used toner bottle motor operates a cam which vibrates against the side of
the used toner bottle. This vibration settles and evens the level of the used toner
inside the bottle.
1 Used Tnr M (Sensor Detection)
Sets the length of time that the used toner bottle motor operates. The motor
starts 10 sec. after the main power switch is switched on and if the fusing
temperature is less than 50°C (122
o
F).
[0 to 30/20/5]
Note: Ten seconds after the machine is switched on if the machine detects that
the toner collection bottle is full, the used toner bottle motor does not operate.
2 Used Tnr M (TE Recovery)
Sets the length of time that the used toner bottle motor operates after TE (toner
end).
[0 to 80/30/5 sec.]
3 Used Toner Bottle Full Detect
Sets the length of paper that can be printed from the time the toner bottle is
detected near full until the used toner bottle is detected completely full.
[1 to 50/30/1 m]
To Next Page
Loading...
