Overview
SM 2-29 D093/D094
Product
Information
NUMBER NAME DESCRIPTION
SW13
Anti-condensation
Heater Switch
Switches the anti-condensation heaters on/off
in the main machine. There are two 13W
heaters, one located at either end of the OPC
drum. These heaters operate only when the
main switch is switched off.
Others
CO1 Recycle Counter
A mechanical counter that measures the total
length in meters of paper that the machine
feeds. It starts from the first copy.
H1
Dehumidifier 1
(Front/Right)
One of four dehumidifiers that keeps the roll
feeder drawer free of moisture.
H2
Dehumidifier 2
(Front/Left)
H3
Dehumidifier 3
(Rear/Right)
H4
Dehumidifier 4
(Rear/Left)
H5
Anti-Condensation
Heater (Left)
These are below the OPC drum. They keep
the copier free of moisture, which could cause
problems with paper feed and fusing.
H6
Anti-Condensation
Heater (Right)
HDD1 HDD Hard Disk Drive. One unit: 160 GB
TH1 Hot Roller Thermistor
The CPU uses this thermistor to monitor the
temperature of the hot roller.
TH2
Pressure Roller
Thermistor 1 (Edge)
The CPU uses these thermistors to monitor
the temperature of the pressure roller.
TH3
Pressure Roller
Thermistor 2
To Next Page
Loading...
