Ricoh D093 - Page 735

SP8-xxx Data Log 2
SM Appendix 2-213 D093/D094
Appendix:
SP Mode
Tables
8211 T:Scan PGS/LS These SP's count the number of pages scanned in to
the document server .
[0 to 9999999/ 0 / 1]
The L: counter counts the number of pages s to red
from within the document server mode screen at the
operation panel, and with the Store File but to n from
within the Copy mode screen
8212 C:Scan PGS/LS
8215 S:Scan PGS/LS
8216 L:Scan PGS/LS
 Reading user stamp data is not counted.
 If a job is cancelled, the pages output as far as the cancellation are counted.
 If the scanner application scans and stores 3 B5 sheets and 1 A4 sheet, the S: count is 4.
 If pages are copied but not stored on the document server, these counters do not change.
 If both sides of 3 A4 sheets are copied and stored to the document server, the C: count is 6
and the L: count is 6.
 If you enter document server mode then scan 6 pages, the L: count is 6.
8221
ADF Org Feeds [0 to 9999999/ 0 / 1]
These SP's count the number of pages fed through the ADF for front and back
side scanning.
1 Front
Number of front sides fed for scanning:
With an ADF that can scan both sides simultaneously, the Front side
count is the same as the number of pages fed for either simplex or
duplex scanning.
With an ADF that cannot scan both sides simultaneously, the Front
side count is the same as the number of pages fed for duplex front
side scanning. (The front side is determined by which side the user
loads section up.)
2 Back
Number of rear sides fed for scanning:
With an ADF that can scan both sides simultaneously, the Back count
is the same as the number of pages fed for duplex scanning.
With an ADF that cannot scan both sides simultaneously, the Back
count is the same as the number of pages fed for duplex rear-side
scanning.