SP8-xxx Data Log 2
SM Appendix 2-219 D093/D094
Appendix:
SP Mode
Tables
838x 5 Area (Low) Total area coverage
Note:
The values for "Length" are displayed in mm. If a "Length" reading is
"42126" this is 42,126 mm (42.126 m).
The values for "Area" are displayed as mm
2
. If an "Area" reading is
"33213257" this is 33,213,257 mm
2
(33,213.257 m
2
).
The counts for the "Length" and "Area" start with "Low". Once the
count exceeds the width of the field on the display the "Low" field will
reset to "0" and the count overflows to the "High" SP codes. (This is
necessary because the fields of the "Low" SP codes are limited to 8
digits and not wide enough to display the full reading for a reading
larger than 8 digits.)
Always check the "Low" SP first. If the "Low" display is zero, check the
"High" field.
When the length count reaches "99,999,999" in the "Low" field (8
digits), for example, after the next copy the count will show "1" in the
"High" field and "00 000 000" in the "Low". Multiply the "1" in the
"High" field by: 1) 10
8
" (100,000,000 mm), 2) 10
5
(100, 000 m) or 3)
10
2
(100 kilometers) to determine the accurate count.
When several documents are merged for a print job, the number of pages s to red are
counted for the application that stored them.
These counters are used primarily to calculate charges on use of the machine, so the
following pages are not counted as printed pages:
Blank pages in a duplex printing job.
Blank pages inserted as document covers, chapter title sheets, and slip sheets.
Reports printed to confirm counts.
All reports done in the service mode (service summaries, engine maintenance reports, etc.)
Test prints for machine image adjustment.
Error notification reports.
Partially printed pages as the result of a jam.
8401 T:PrtPGS/LS
These SP's count the number of pages printed from the
document server. The counter for the application used to
print the pages is incremented.
The L: counter counts the number of jobs stored from
8402 C:PrtPGS/LS
8404 P:PrtPGS/LS
To Next Page
Loading...
