116
3 Producing with the knitting machine
Eliminating errors in the fabric
5. When the fabric is long enough to be placed in the main take-down, or the
belt take-down, stop the machine with the engaging rod.
6. Open the main take-down or the belt take-down, place the fabric in the
main take-down or the belt take-down and close the take-down.
7. To start the knitting program, tap the "SP from line
1" key.
8. Start the machine with the engaging rod.
"Picking-up after pressing-
off" funct
ion with an M1
pattern
Requirements:
The knitting program was generated on M1
When the pattern is generated, the "P.aft. press-off"
menu item is
activated
Machine start window
"Machine start" window
NOTICE
If you notice defective needles while picking-up after pressing-
off:
➜ Stop picking-up after pressing-off and replace the defective
needles
.
Setting
Function
#90=0
"Picking-up after pressing-off" function is deactivated
#90=1
"Picking-up after pressing-off" function is activated. A specific row
number (gauge x 4) is knitted, depending on the gauge of the
machine. A total of 40 knitting rows are processed for a machine of
gauge E10.
#90=n
If this is too many knitting rows, "#90" can be set to another number.
Two knitting rows, similar to the "Picking-up after pressing-off"
function, are repeated as often as "#90" is set. Example: #90=15. A
total of 30 knitting rows (2 x 15) are processed.
#L, #R
Setting the fabric width for the "Picking-up after pressing-off" function.
Default set
ting: Starting width (#L=#51, #R=#52)
To Next Page
Loading...