143
Adjusting knitting machine 4
Basic settings
Tandem machine: Correction of the yarn carriers in the right carriage (Setup1, Setup2)
Tandem machine: Correction
of the yarn carriers in the
right carriage (Setup1,
Setup2)
If the carriages have a wide coupling, the stopping positions of
the yarn
carr
iers in the right carriage can be corrected (column "Right offset"). It may,
for example, be necessary to carry out corrections at very fine fabrics or at
special intarsia patterns. Possible reasons for a correction:
diff
erent wear of the yarn carriers used in the left and right carriages
different wear of the yarn carrier rails
different lubrication
different directions of the yarn feed
in the left
and right carriages
Yarn carrier co rrection window du ring tandem opera tion
"Yarn carrier correction" window during tandem operation
Data in the Yarn carrier correction window
Data in the "Yarn carrier correction" window
Column
Data shown
"YL"
Specification of the yarn carrier in the left carriage.
"YR"
Specification of the yarn carrier in the right carriage.
"Oa"
Right carriage during tandem operation: Yarn carrier
correction value a (stopping position on the left).
Value range: -8...0...8 . Step width: 0.5=1/32 inch=0.8 mm
The correction value refers to the stop value of the left
carriage.
"-b"
Right carriage during tandem operation: Yarn carrier
correction value b (stopping position on the right).
Value range: -8...0...8 . Step width: 0.5=1/32 inch=0.8 mm
To Next Page
Loading...