236
4 Adjusting knitting machine
Advanced adjustments
18. If all of the yarn carriers are checked, tap the "ctrl W" key. It will be
proceeded to the next partial program automatically.
- or -
➜ If all the partial programs are proces
sed, the adjustment program is
automatically exited and the production is started.
The checking is completed.
Possibl
e reasons for the
wrong sto
pping position
Different lubrication
Different cleaning of the yarn carrier rails
Temperature variation during the production
Adjusting yarn carrier guide
Pressure plates are worn
The yarn carrier is bent (very dif
ferent braking
values for the left and the
right-hand side)
Further information:
Adjusting yarn carrier guide [224]
Intarsia yarn carrier - check
the pr
essure plates * [237]
If you have set the yarn carrier correction values to "0", then
enter the noted values in the knitting program.
➜ If some braking values are modified, then the data are
automatically saved in the data specific to the machine
(dongle data).
➜ Th
e braking values do not depend on
the patterns, but on
the machine. These data are therefore not deleted when a
new knitting program is loaded.
➜ Th
e braking values always remain saved, even when the
operating syst
em is loaded again.
➜ If the braking values are no longer required, they have to be
reset to "0"
manually.
➜ Check the braking values from time to time as th
e
conditions may change.
➜ With tandem operation: Separate braking values cannot be
entered for the yarn carrier
s in the right carriage.
To Next Page
Loading...