398
7 Repairing the knitting machine
Replacing parts
17. Insert the holding-down jack and the support with slight rotary movements
in the jack bed.
18. Ensure that the spring engages in the holding-down jack.
19. Reassemble the needle bed in the reverse order.
Further information:
Helpful knitting rows [378]
Remove needle bed or position it at an angle [399]
Screwing on needle bed tight
Screwing on needle bed tight
Installing front and rear needle beds
Installing front and rear needle beds
➜ Reassemble the needle bed in the reverse order. When doing so, make
sure that the needle bed contacts the pin (1) and the roller (2).
To Next Page
Loading...