407
Repairing the knitting machine 7
Replacing parts
9. When mounting the selection jack bed, make sure that it rests on the pin
(6).
Installing selection jack bed
Installing selection jack bed
with CMS 830 C 1. Stop the carriage assembly into the left reversing position.
2. Remove needle bed. Lay the needle bed on a flat surface (e.g. workbench
or tabl
e).
3. Push the intermediate sliders (1) into their highest pos
ition.
Lifting sele ction jac ks
Lifting selection jacks
4. Remove two screws (2) on each side of the machine.
Releasin g the selec tion jack b ed
Releasing the selection jack bed
5. Remove the screws (3) of the clamping pieces (4) over the entire length of
the selection jack bed.
6. loosen both grub screws (5) at eac
h clamping piece. Move clamping piece
to the side and remove it.
7. Push the selection jacks (6) into their highest position.
To Next Page
Loading...