408
7 Repairing the knitting machine
Replacing parts
8. Starting from one side, lift the selection jacks at their top end while
simultaneously pushing the wire (7) out of the accessory between the
selection jack bed and the selection jack. Carry this out over the entire
length of the selection jack bed. The wire must be pushed in so that the
working butts of the selection jacks stick out so high that they touch neither
the intermediate slider nor the needle bed.
9. Take off the selection jack bed.
10. When mounting the selection jack bed, make s
ure that it rests on pin (8).
Installing selection jack bed
Installing selection jack bed
11. Mounting the clamping pieces: Insert clamping piece and push it to the
side. Secure it with the screw (3) and then tighten the grub screws (5).
Further information:
Remove needle bed or position it at an angle [399]
To Next Page
Loading...