491
Software - Installation and basic settings 8
Installing the Stoll operating system
6. Confirm selection.
The installation process gets started.
The "Language" window is displayed after having selected the "Installation
and Configuration
" key.
- or -
The "Reference runs " win
dow is disp
layed after having selected the
"Installation" key.
7. If the "Language" window is displayed, con
tinue with the "Machine
configuration" section.
- or -
➜ If the "Reference runs" window is disp
layed, continue with the section
"Start reference runs".
Configure Machine The "Language" window is displayed.
1. Select the
dialog language and confirm the selection.
2.
Proceed to the next window.
The "Machine configuration" window is displayed. The data have been
set at the factory and will not be changed.
3.
Proceed to the next window.
The "Machine configuration 2" window is displayed. The data have
been set at the factory and will not be changed.
4. P
roceed to the next window.
The "Machine Options" window is displayed. The d
ata is set at the
factory.
5. If necessary, change the data and confirm
the changes.
6. Proceed to the next window.
The "Machine Parameter" window is displayed. The data is set at the
factory.
7. If necessary, change the data and confirm
the changes.
8. Proceed to the next window.
The "Needle bed parameters" window is displayed. The data is set at
the factory.
9.
If necessary, change the data and confirm
the changes.
10. Proceed to the next window.
Th
e "NPK-Values" window is displayed. The data is set at the factory.
Machine fault!
The presence or lack of machine options must correctly be
s
pecified, as otherwise a fault may occur on the machine.
Always specify the machine optio
ns correctly.
To Next Page
Loading...