Status and Events
Table 3-5: Execution Error Messages (EXE Bit 4) (cont.)
Code Message
2210
Measurement error, No Mid Ref crossing, second waveform
2211
Measurement error, No backwards Mid Ref Crossing
2212 Measurement error, No negative crossing
2213 Measurement error, No positive crossing
2214 Measurement error, No crossing
2215
Measurement error, No crossing, second waveform
2216
Measurement error, No crossing, target waveform
2217
Measurement error, Constant waveform
2218 Measurement error, Unused
2219 Measurement error, No valid edge – No arm sample
2220 Measurement error, No valid edge – No arm cross
2221 Measurement error, No valid edge – No trigger cross
2222 Measurement error, No valid edge – N o second cross
2223
Measurement error, Waveform mismatch
2225
Measurement error, No waveform to measure
2226
Measurement error, Null Waveform
2227
Measurement error, Positive and Negative Clipping
2228
Measurement error, Positive Clipping
2229
Measurement error, Negative Clipping
2230
Measurement error, High Ref < Low Ref
2231 Measurement error, no statistics available
2241
Waveform request is invalid
2243
This measurement cannot be performed on this type of waveform
2244
Source waveform is not active
2248
This ref cannot be activated
2249
Reference deletion error, Waveform in use for math
2250
Reference error, Waveform reference file is invalid
2251
Reference error, Waveform preamble does not match actual
2252
Reference error, Source waveform is not valid
2253
Reference error, Too many points received
2254
Reference error, Too few points received
2259 File too big
2261
Calibration error, wait for the warm-up interval to expire before invoking SPC
2400 Not enough memory available
2401 This channel cannot be activated
2402
Math/Meas/Histo have circular definition
2410 Empty m ath string
3-14 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
