X35 Monitor Air Seeder Setup
6.8
6. If Bourgault was selected (Figure 6.7), the
next screen will show the configuration folder.
Refer to Figure 6.8.
a. Once the configuration folder is selected,
the list of drill sizes will be displayed.
i. Select your drill size.
b. Next, a list of configurations (spacing,
presence of granular sectional control,
optional high flotation) for the selected size
will appear.
i. Select your drill configuration.
c. A naming convention is used to help easily
identify the required configuration. Refer
to Step d.
d.
The
following examples explain the naming convention:
i. 3320-76 10SPCG - is a Model 3320, 76' width, 10" spacing
ii. 3320-76 12SPCG HF - is a Model 3320, 76 width, 12" spacing, High flotation frame
iii. 3320-66 10SPCG (GRAN SCN) HF - is a Model 3320, width 66', 10" spacing, granular
sectional control, High flotation frame
iv. 5810-62 9.8SPCG (GRAN SCN) - is a Model 5810, width 62', 9.8" spacing, granular
sectional control
To Next Page
Loading...
