Chapter 53 Provisioning User Interfaces
OLT2406 User’s Guide
406
2 Set the transceiver type of the PON port. This example displays the mapping between the transceiver
type number from 0 to 22 and the transceiver manufacturer and class. The PON port in this example has
a LIGENT class B transceiver installed so this example uses transceiver type 5.
3 Set the method (A, C, C-autolock, D, or E) the OLT registers ONTs connected to the port.
• A: (Used in this example) requires the serial number and password the ONT sends to match the ones
you configure on the OLT.
• C: The ONT must match either the serial number or the password configured on the OLT.
• C-autolock: Requires the serial number the ONT sends to match the one you configure on the OLT.
• D: Automatically registers the ONT and brings it into service without checking the serial number or
password. The ONT registered with format D will lose the template settings when it’s not connected to
the OLT. If the ONT is discovered the next time, the OLT will apply the template according to the
settings configured in the Advanced Application > OLT Registration screen automatically. The ONT
may receive a different ONT ID when it reconnects.
OLT2406# config
OLT2406(config)# interface slot slot-6
OLT2406(config-slot)# cardtype gpon
OLT2406(config-slot)# no inactive
OLT2406(config-slot)# exit
OLT2406(config)# exit
OLT2406# config
OLT2406(config)# interface olt pon-6-1
OLT2406(config-olt)# transceiver 99
Transceiver type
LIGENT = 0
LUMINENT = 1
FIBERXON = 2
FUJITSU = 3
LIGENT_A = 4
LIGENT_B = 5
LIGENT_C = 12
LUMINENT_A = 6
LUMINENT_B = 7
FIBERXON_A = 8
FIBERXON_B = 13
FUJITSU_A = 9
NEC = 10
NEOPTEC = 11
FUJITSU_30537 = 14
NEOPHOTONICS_A = 15
NEOPHOTONICS_B = 16
NEOPHOTONICS_C = 17
SUPERXON = 18
WTD = 19
1 = 21
2 = 22
OLT2406(config-olt)# transceiver 5
To Next Page
Loading...
