Chapter 53 Provisioning User Interfaces
OLT2406 User’s Guide
407
• E: Automatically registers the ONT and brings it into service without checking the serial number or
password. The ONT registered with format E will keep the template settings even when the it’s not
connected to the OLT. If the ONT is discovered the next time, it has the template settings already, so
the OLT won’t apply the template again. The OLT records the SN/ONT ID mapping and uses the same
ONT ID for the ONT when it reconnects.
If you select method D or E, create a template with a number between 121 and 128, and enable the
PON port.
Check the slot’s status.
4 Configure the QoS ingress profile and bandwidth profiles and then check the configuration.
• ingprof: The QoS ingress profile maps IEEE 802.1p priority tags to traffic classes. This example’s “voip”
QoS ingress profile maps IEEE 802.1p tags 0 to 7 to traffic class 1.
• bwprof: Bandwidth profiles have Sustained Information Rate (SIR), Access Information Rate (AIR), and
Peak Information Rate (PIR) settings for limiting bandwidth. Note that an upstream bandwidth profile is
determined by the SIR, AIR, and PIR parameters respectively in the following figure.
Figure 247 Upstream Bandwidth Profile
OLT2406(config-olt)# register-method E template-option <125>
OLT2406(config-olt)# no inactive
OLT2406(config-olt)# exit
OLT2406(config)# exit
OLT2406(config-olt)# register-method A
OLT2406(config-olt)# no inactive
OLT2406(config-olt)# exit
OLT2406(config)# exit
OLT2406# show interfaces slot slot-6 status
AID | Base_Address IP0 IP1 MAC0
MAC1 Support_Link
----------------------+-------------------------------------------------------------------------
---------------------------
slot-6 | 0x be000000 127.168.0.1 127.168.0.2 00:19:cb:13:57:28
00:19:cb:13:57:29 0
+-------------------------------------------------------------------------
-----------------------------
| Details
+-------------------------------------------------------------------------
-----------------------------
| Status: READY
| Device Version: 0x2060701
| Driver Version: 0
| Firmware Date: Dec 25 2012, 17:50:33
----------------------+-------------------------------------------------------------------------
---------------------------
To Next Page
Loading...
