ZyXEL Communications OLT2406 - Page 576

Chapter 78 VoIP
OLT2406 User’s Guide
576
7 Use the remote uniport <aid> command to configure settings on a card type, an ONT’s Ethernet
interface, and an ONT’s VoIP interface.
<aid>: uniport-<slot>-<pon>-<ont>-<card>-<port>
8 Configure VLAN flow and VoIP service settings for the UNI (subscriber) port on the remote ONT.
• The subscriber User Network Interface (UNI) port at slot 5, port 1, ONT 1, card 2, card port 1.
• QoS queue: configure QoS settings to apply to a specific traffic class.
• tc: traffic class 0-7 to which to apply this queue, 1 in this example.
• priority: 0-7 to apply to the traffic class, 2 in this example.
• weight 0-255 to use for the traffic class, 2 in this example.
• usbwprofname: the bandwidth profile for the traffic class’s upstream traffic (100m here).
• dsbwprofname: the bandwidth profile for the traffic class’s downstream traffic (100m here).
• bwsharegroupid: this example uses bandwidth group ID 1.
• VLAN settings:
• VLAN: apply this command's QoS ingress profile to UNI VLAN 20 traffic.
• ingprof: apply the alltc1 QoS ingress profile to apply to the VLAN’s traffic.
• VoIP service settings:
•mode: sip.
• VLAN: UNI VLAN 20.
• common-profile: common.
• sip-profile: sip.
• SIP username: 812202.
• password: 812202.
• dial-plan: dial.
OLT2406# config
OLT2406(config)# remote ont ont-5-1-1
OLT2406(config-ont)# sn 5A59584517035116
OLT2406(config-ont)# password 44454641554C54000000
OLT2406(config-ont)# no inactive
OLT2406(config-ont)# bwgroup 1 usbwprofname 100m dsbwprofname 100m
OLT2406(config-ont)# exit
OLT2406(config)# exit
OLT2406# config
OLT2406(config)# remote uniport uniport-5-1-1-2-1
OLT2406(config-uniport)# queue tc 1 priority 2 weight 2 usbwprofname 100m
dsbwprofname 100m bwsharegroupid 1
OLT2406(config-uniport)# vlan 20 ingprof alltc1
OLT2406(config-uniport)# exit
OLT2406(config)# remote uniport uniport-5-1-1-3-1
OLT2406(config-uniport)# voip-service mode sip vlan 20 common-profile common sip-
profile sip username 812202 password 812202
OLT2406(config-uniport)# exit
OLT2406(config)# exit