ZyXEL Communications OLT2406 - Page 616

Chapter 85 Access Control
OLT2406 User’s Guide
616
snmp-server username <name> sec-
level <noauth|auth|priv> [auth
<md5|sha> auth-password
<password>] | [priv <des|aes> priv-
password <password>] group <group-
name>
Sets the authentication level for SNMP v3 user
authentication. Optionally, specifies the
authentication and encryption methods for
communication with the SNMP manager.
name: Enter the SNMP username.
noauth: Use the username as the password
string sent to the SNMP manager. This is
equivalent to the Get, Set and Trap Community
in SNMP v2c. This is the lowest security level.
auth: Implement an authentication algorithm
for SNMP messages sent by this user.
priv: Implement privacy settings and
encryption for SNMP messages sent by this user.
This is the highest security level.
auth-password: Set the authentication
password for SNMP messages sent by this user.
priv-password: Set the privacy settings
password for SNMP messages sent by this user.
group: Set the View-based Access Control
Model (VACM) group. Available group names
are:
admin: The user belongs to the admin group
and has maximum access rights to the OLT.
readwrite: The user can read and
configure the OLT except for confidential
options (such as user account and AAA
configuration options.)
readonly: The user can read but cannot
make any configuration changes.
Note: The settings on the SNMP manager
must be set at the same security
level or higher than the security level
settings on the OLT.
C14
no snmp-server username <name>
Removes the specified SNMP user’s information. C 14
show snmp-server [user]
Displays the SNMP information on the OLT. The
user flag displays SNMP user information.
E3
Table 324 snmp-server trap-destination enable traps Commands
COMMAND DESCRIPTION M P
snmp-server trap-destination <ip>
enable traps
Enables sending SNMP traps to a manager. C 13
no snmp-server trap-destination
<ip> enable traps
Disables sending of SNMP traps to a manager. C 13
snmp-server trap-destination <ip>
enable traps aaa
Sends all AAA traps to the specified manager. C 13
no snmp-server trap-destination
<ip> enable traps aaa
Prevents the OLT from sending any AAA traps to
the specified manager.
C13
snmp-server trap-destination <ip>
enable traps aaa <options>
Sends the specified AAA traps to the specified
manager.
C13
Table 323 SNMP Server Commands (continued)
COMMAND DESCRIPTION M P