ZyXEL Communications OLT2406 - Page 658

Chapter 96 Remote ONT
OLT2406 User’s Guide
658
The following table introduces commands for configuring remote ONTs. Refer to the OLT’s help for
information about the command sub-options.
Table 352 Remote ONT Commands
COMMAND DESCRIPTION M P
remote ont <aid>
Configures Remote ONT settings.
aid: ont-<slot>-<pon>-<ont>
C13
acl-service <1-16> name
<profile-name>
Assigns an ACL service number to an ACL profile
for the remote ONT.
C13
no acl-service <1-16 | all>
Removes a specified or all ACL profiles from the
remote ONT.
C13
alarm-profile <name>
Creates an ONT alarm profile to monitor the
DDMI status of the ONT transceiver under
configure mode.
name: ONT alarm profile name.
Use the following commands to create an ONT
alarm profile:
OLT2406(config)# ont-alarm-profile
TEST
OLT2406(config-ont-alarm-profile)#
Specify the lower and upper bounds for the
laser bias current threshold, temperature
threshold and power feed voltage threshold.
Then apply the alarm threshold profile to an
ONT. The default alarm profile monitors no DDMI
information.
C13
anti-mac-spoofing inactive
Disables anti-MAC spoofing for the remote ONT. C 13
no anti-mac-spoofing inactive
Enables anti-MAC spoofing for the remote ONT. C 13
bwgroup <id> usbwprofname
<usbwprofname> dsbwprofname
<dsbwprofname>
Sets the bandwidth group profile for the remote
ONT.
id: 1-40
usbwprofname: Upstream bandwidth profile
name
dsbwprofname: Downstream bandwidth profile
name
C13
bwgroup help
Provides more information about the specified
command.
C13
no bwgroup <id | all>
Deletes bandwidth group profiles for the remote
ONT.
id: 1-40, delete the specified bandwidth group.
all: Delete all bandwidth groups in the remote
ONT.
C13