ZyXEL Communications OLT2406 - Page 667

Chapter 96 Remote ONT
OLT2406 User’s Guide
667
show remote ont <cr>
Displays all ONT information. E 3
show remote ont filter < slot-<aid>
| pon-<aid> | <serial number> | is
| oos-nr .. >
Displays the status of ONTs matching the filter
you specify.
slot-<slot>: Show ONT information by slot.
pon-<aid>: Show ONT information by PON port.
is: Show ONTs with an IS (In Service) status.
oos: Show ONTs with an OOS (Out Of Service)
status.
oos-lo: Show ONTs with a Line Card Out Of
Service status.
oos-nr: Show ONTs with an Out Of Service Not
Registered status.
oos-cd: Show ONTs with an Out Of Service
OMCC Down status.
oos-np: Show ONTs with an Out Of Service Not
Provisioned status.
oos-ad: Show ONTs with an Out Of Service
Admin Down status.
oos-op: Show ONTs with an Out Of Service
Operation Down status.
E3
show remote ont summary
Displays a summary of ONT status. E 3
show remote ont unreg
Displays unregistered ONT status information. E 3
show remote ont template <aid>
Displays ONT template information for the
specified template.
aid: slot-<slot> | pon-<slot>-
<pon> | ont-<slot>-<pon>-<121~128>
E13
show remote ont template
Displays all ONT template information. E 3
show remote ont <aid> status-
history
Displays the ONU status history.
aid: ont-<slot>-<pon>-<ont>
E13
show remote ont <aid> wan-status
Displays the ONT WAN status.
aid: ont-<slot>-<pon>-<ont>
E13
remote ont <aid> onu-
reset[<1>|<2>]
Resets the ONU.
1: Load factory default
2: Reset default
aid: ont-<slot>-<pon>-<ont> | pon-
<slot>-<pon>
E13
remote ont <aid> config-status
Gets the ONT’s current configuration status.
aid: ont-<slot>-<pon>-<ont> | pon-
<slot>-<pon>
E13
ont-alarm-profile <name>
Sets the ONT alarm profile name.
name: up to 32 ASCII characters
C13
Table 352 Remote ONT Commands (continued)
COMMAND DESCRIPTION M P