ZyXEL Communications OLT2406 - Page 705

OLT2406 User’s Guide
705
pppoe intermediate-agent option82
circuit-id vlan <vid> option82-
info <info>
Enters a string of up to 127 ASCII characters that
the OLT adds into the option 82 Circuit ID
suboption for PPPoE discovery packets received
in the VLAN group.
<info>: The string should be composed of the
following special characters. The special
characters listed in the brackets [~`!@#$^&*()]
are not allowed except % and space.
• %%: character %
• %space: character space
• %mac: client source mac
• %hname: host device name
• %slotid: slot index of the logic port
• %pid: pon port index
• %oid: ONT index
• %ocid: ONT card index
• %upid: uniport index
• %nnisvlan: SVLAN ID on network-network
interface
• %snisvlan: SVLAN ID on service-network
interface
Note: If the string is composed of more
than 127 characters, the string will be
truncated to the maximum number
of characters allowed when the OLT
transforms the string into the Circuit
ID.
C13
pppoe intermediate-agent option82
remote-id vlan <vid> option82-info
<info>
Enters a string of up to 95 ASCII characters that
the OLT adds into the option 82 Remote ID
suboption for PPPoE discovery packets received
in the VLAN group.
<info>: The string should be composed of the
following special characters. The special
characters listed in the brackets [~`!@#$^&*()]
are not allowed except % and space.
• %%: character %
• %space: character space
• %mac: client source mac
• %hname: host device name
• %slotid: slot index of the logic port
• %pid: pon port index
• %oid: ONT index
• %ocid: ONT card index
• %upid: uniport index
• %nnisvlan: SVLAN ID on network-network
interface
• %snisvlan: SVLAN ID on service-network
interface
Note: If the string is composed of more
than 95 characters, the string will be
truncated to the maximum number
of characters allowed when the OLT
transforms the string into the Remote
ID.
C13
pppoe intermediate-agent option82
help
Provides more information about the specified
command.
C13
Table 371 PPPoE Intermediate Agent Commands (continued)
COMMAND DESCRIPTION M P