Alcatel-Lucent OmniAccess 5740 - Page 139

Configure
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
129
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
CONFIGURE RULE
Step 1: Select the Configure Rule radio button to define the rules to a match-list.
By default this radio button is selected.
Select any of the protocols from the Protocol drop down list: IP/TCP/UDP/ICMP/
Protocol/AH/ESP/GRE/OSPF/IGMP. Rule elements vary for each of the
protocols, and is displayed under MatchList Details table.
Step 2: Enter the rule number to specify the rule priority in the Priority field.
Step 3: Select source from the Source drop-down list: ANY/HOST/PREFIX/
INTERFACE/LIST.
• Enter the source IP address for Host.
• Enter the source address with prefix length for Prefix.
• Select the interface from the interfaces list for Interface.
• Select the list from the lists configured for List.
Step 4: Select the destination from the Destination drop-down list: ANY/HOST/
PREFIX/INTERFACE/LIST.
• Enter the destination IP address for Host.
• Enter the destination address with prefix length for Prefix.
• Select the interface from the interfaces list for Interface.
• Select the list from the lists configured for List.
Step 5: Select rule elements for the protocols.