Configure
Left running head:
Chapter name (automatic)
232
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Alcatel-Lucent
C
ONFIGURING SENSORS
Follow the procedure below to configure sensors.
Step 1: Click New in Sensors page. Create a New Intrusion Sensor page is
displayed.
Figure 147: Intrusion Prevention: Sensor - New
Step 1: Select the sensor type in the Type drop-down list in the Sensor box.
Step 2: Enter the name for new sensor in Name field in Sensor box.
Step 3: Enter the Rate Threshold values. These are optional.
• Enter the rate threshold packet value for the sensor in Packets field in Rate
Threshold box. The rate threshold packet value is in the range of 1-4294967295.
• Enter the rate threshold time in Per Milli Seconds field. The rate threshold time
value is in the range of 1-4294967295 milli seconds.
This denotes the threshold time in milliseconds inside which if the specified
threshold number of packets are received, those packets are treated as attacks.
Step 4: Click Apply to add new intrusion sensor.
To Next Page
Loading...
