Configure
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
49
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Figure 25: Interfaces - Configure MLFR Encapsulation on a Channelized
Serial Interface
Note: If the encapsulation of a serial interface is changed to MLFR from HDLC/PPP/FR, the
QoS policy applied on the serial interface will be detached.
2. Each MLFR interface is identified by a bundle ID. The interface becomes a
member link of the bundle interface identified by the bundle ID. Select the bundle
identifier from the Bundle Identifier drop-down list.
3. Enter the bundle identification (BID) name to the bundle interface in the
Description field.
4. Enter the Maximum Packet size or Maximum Transmission Unit (MTU) size in the
MTU field. The default MTU on an MLPPP bundle interface is 1494.
5. Enter the Link Identification name to the interface that is part of the bundle in the
LID field. The LID can be a maximum of 255 characters.
6. Enter the hello-interval in the Hello-interval field. Hello interval is the duration in
seconds between successive hello messages sent.
7. Enter the ack-interval in the Ack-interval field. Acknowledge interval is the
duration (in seconds) that the bundle link waits for a hello message from its peer,
or the duration it waits before resending the hello message.
8. Enter the retry-count in the Retry-count field. Retry count is the number of times
the bundle link will send out a hello message before any acknowledgment is
received from its peer.
9. After configuring the parameters, click Apply to save the MLFR configuration or
click Cancel to cancel the operation.
To Next Page
Loading...
Need help?
General
