Configure
Left running head:
Chapter name (automatic)
46
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Alcatel-Lucent
Figure 23: Interfaces - Configure MLPPP Encapsulation on a Channelized
Serial Interface
Note: If the encapsulation of a serial interface is changed to MLPPP from HDLC/PPP/FR,
the QoS policy applied on the serial interface will be detached.
2. Each MLPPP interface is identified by a bundle ID. The interface becomes a
member link of the bundle interface identified by the bundle ID. Select the bundle
identifier from the Bundle Identifier drop-down list.
3. Enter the bundle identification (BID) name to the bundle interface in the
Description field.
4. Enter the Maximum Packet size or Maximum Transmission Unit (MTU) size in the
MTU field. The default MTU on an MLPPP bundle interface is 1494.
5. On some links, it may be desirable to require a peer to authenticate itself before
allowing network-layer protocol packets to be exchanged. To enable this
authentication, PPP supports authentication protocols such as PAP, CHAP, EAP
(CHAP - Challenge Authentication Protocol, PAP - Password Authentication
Protocol, EAP - Extensible Authentication Protocol). Authentication is not
mandatory.
Set the authentication protocol for authenticating the peer by selecting the option
from PPP Authentication drop down list: Chap/Pap/Eap/None
To Next Page
Loading...
Need help?
General
