Configure
Left running head:
Chapter name (automatic)
76
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Alcatel-Lucent
2. Similarly select the required NAT, Firewall, QoS, Transparent Firewall, Policy
Based Routing policies to be attached to the interface in the Ingress and Egress
direction from their respective fields.
The In Direction and Out Direction drop-down lists displays the NAT, Firewall,
QoS, Transparent Firewall, Policy Based Routing policies already configured
in your system.
If NAT policy is not configured, see “Creating Source NAT (SNAT) Policy and
Configure NAT Rule”/“Creating Destination NAT (DNAT) Policy and Configure
NAT Rule” section.
If Firewall policies are not configured, see “Creating Firewall Policy” section.
If QoS policies are not configured, see “QoS (Quality of Service)” section.
If Transparent Firewall policies are not configured, see “Creating TF Policy”
section.
If Policy Based Routing policies are not configured, see “Configuring an IP
Policy and a Rule for an IP Policy” section.
3. Attach an IPSec policy.
• Select the IPSec policy/policies to be attached to the interface from the list.
The IPSec policies already configured in your system is displayed. Check the
check box against the IPSec policy/policies.
If IPSec policies are not configured, see “IPSec Configuration Wizard”
section.
Step 2: Click OK to attach the policy/policies to an interface or click Cancel to
cancel the operation.
V
IEW INTERFACE DETAILS
Follow the procedure given below to view the details of a selected interface:
1. In the Interfaces page, click Interface Name whose configuration details are to
be viewed.
2. The interface details for the selected interface are displayed in the Interface
Details table. The details displayed vary based on the selected interface.
To Next Page
Loading...
Need help?
General
