Alcatel-Lucent OmniAccess 5740 - Quality of Service: Policy Map - New Traffic Class Policing Configuration - Committed Rate

Configure
Left running head:
Chapter name (automatic)
262
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
Alcatel-Lucent
2. Enable policing.
Select the Enable Policing check box.
3. Select and set the policing parameters. This configures the policer on the
particular traffic-class of the policy map.
There are three Police Parameters available: Committed Rate, Committed
Burst, and Excess Burst.
i. Select Committed Rate option in the Police Parameters box. The
Committed Rate Parameters fields are displayed as shown below.
Figure 169: Quality of Service: Policy Map - New Traffic Class Policing
Configuration – Committed Rate