Alcatel-Lucent OmniAccess 5740 - NAT

Configure
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
157
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway Web GUI Users Guide
NAT
This page allows you to add/or edit the NAT policies.
OmniAccess 5740 USG Specific Overview
• In OmniAccess 5740 USG, NAT is applied to an interface.
• Configuration allows for load-balancing in DNAT if a pool of IP addresses are
used.
• Port ranges used for translation can be explicitly specified.
• For Source NAT, if no IP pool or host address is specified, the default is the box's
IP address of the egress interface on which the NAT policy is applied.
V
IEWING NAT
Follow the procedure given below to view NAT page.
Step 1: Launch the Web GUI tool.
Step 2: From the USGM menu bar, click Configure. All submenu/links under
Configure are displayed in the left navigation panel.
Step 3: Click Firewall sub-menu.
The Firewall has the following tabs: Firewall Wizard, Filters, NAT, DOS Attack,
Transparent Firewall and Firewall Policy. Select NAT tab. NAT page is
displayed in the center panel.